Parts

CHROME MOLLY PUSH RODS (STOCK LENGTH)  INCREASE YOUR RELIABILITY WITH OUR AFTERMARKET STOCK LENGTH CHROME MOLLY PUSH RODS THEY WILL YOUR STOCK ROCK...

This seal fits the 25hp - 40 hp BRIGGS & STRATTON VANGUARD ENGINES

Briggs & Stratton Vanguard EFI Wiring Harness. OEM harness replacement for all vanguard Briggs and Stratton big block engines 37hp , 40hp EFI

Briggs & Stratton Big Block Crank shaft fits ALL VANGUARD LINE ENGINES 35hp carbureted -37hp EFI -40hp EFI 

This intake gasket is the gasket that goes on the front of the cylinder head NOT UNDER THE THROTTLE BODY 

BRIGGS & STRATTON O.E.M. PUSH ROD FACTORY REPLACEMENT PUSH ROD FOR ALL BRIGGS & STRATTON VANGUARD 40 HP EFI, 37 HP EFI, 35 CARBURETED MUD M...

BRIGGS & STRATTON O-RING GALLERY FACTORY REPLACEMENT O RING FOR CYLINDER ASSEMBLY. FITS ALL BRIGGS & STRATTON VANGUARD 40 HP EFI, 37 HP EF...

HAMMER 12.75 X 11 WITH 3/4" HEX PROPELLER Will fit Mud Buddy, and ***NON XD*** Gator tail motors The Hammer Prop should only be used on motors that...

BRIGGS EFI CYLINDER FULLY ASSEMBLED SHORT BLOCK  ***YOU MUST SELECT W/ OR W/ OUT HEADS!!!!*** INCLUDES:  CRANK SHAFT CRANK CASE COVER STOCK RODS &a...

Briggs & Stratton Vangaurd Big Block Intake gasket ***bottom of throttle body***

FITS ALL BRIGGS AND STRATTON VANGUARD BIG BLOCK ENGINES O.E.M Replacement starter. 

AIR FILTER IS A BRIGGS & STRATTON O.E.M REPLACEMENT FOR THE VANGUARD BIG BLOCK ENGINES.   ***Fits 25hp - 40hp EFI***

 IMPROVED BRIGGS O.E.M. HEADS MORE EFFICIENT AND COOLING UP TO 60 DEGREES. HAS A 3 ANGLE VALVE JOB TO INCREASE FLOW. 

BILLET CONNECTING RODS 5.460 (BRINGS PISTON TO ZERO DECK HEIGHT) increasing overall compression to 10:1 ratio Bearings Included! SOLD AS A PAIR Our...

Briggs & Stratton OIL SEAL

This is a Direct O.E.M. replacement piston assembly specifically for the 40hp EFI engines. this piston assembly comes with a standard ring set. not...

O.E.M Briggs & Stratton Replacement High Pressure Fuel Pump for marine Vangaurd Briggs & Stratton EFI Engines.  Compatible with all mud mo...

BRIGGS EFI CYLINDER BLOCK COMPATIBLE FOR 40HP & 37 VANGUARD BRIGGS AND STRATTON 

Compatible with all mud motors (gatortail, mudbuddy, go-devil, prodrive, boss drive, copperhead, mudwalker) Factory O.E.M. replacement piston pins ...

BILLET CONNECTING RODS 5.430 SOLD AS A PAIR Our billet connecting rods are stronger and lighter than those of our competitors. On average, they are...

Allows for mudbuddy made props to be ran on the GATOR TAIL XD lower unit without the need of specialized machine work.